AMIS-30543 Stepper Motor Driver Carrier
This is a breakout board for ON Semiconductor_s AMIS-30543 microstepping bipolar stepper motor driver, which features SPI-adjustable current limiting, 11 step modes (from full-step through 1/128-step), back-EMF feedback that can be used for stall detection or optional closed-loop control, and over-current and over-temperature protection. The board operates from 6 V to 30 V and can deliver up to approximately 1.8 A per phase without a heat sink or forced air flow (it is rated for 3 A per coil with sufficient additional cooling).
This product is a carrier board or breakout board for ON Semiconductor_s AMIS-30543 Micro-Stepping Motor Driver; we therefore recommend careful reading of the AMIS-30543 datasheet (495k pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 3 A output current per coil (see the Power Dissipation Considerations section below for more information). Here are some of the board_s key features:
This product ships with all surface-mount components-including the AMIS-30543 driver IC-installed as shown in the product picture. However, soldering is required for assembly of the included through-hole parts. The following through-hole parts are included:
Three 2-pin, 3.5 mm terminal blocks (for board power and motor outputs)
The 0.1? male header can be broken or cut into smaller pieces as desired and soldered into the smaller through-holes. These headers are compatible with solderless breadboards, 0.1? female connectors, and our premium and pre-crimped jumper wires. The terminal blocks can be soldered into the larger holes to allow for convenient temporary connections of unterminated power and stepper motor wires. You can also solder your motor leads and other connections directly to the board for the most compact installation.
Minimum operating voltage: 6V
Maximum operating voltage: 30V
Continuous current per phase: 1.8A
Maximum current per phase: 3A
Minimum logic voltage: 2.5V
Maximum logic voltage: 5.5V
Microstep resolutions: full, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64, 1/128Reverse voltage protection:Y
1 210,00 от 1 шт
|Внимание! 'Срок' не учитывает дни доставки, которые зависят от выбранного способа получения и адреса доставки.|
Показать еще предложения Скрыть предложения