RGB LED Strip Driver Shield v1.0 / Dfrobot

RGB LED Strip Driver Shield v1.0

The RGB LED Strip Driver Shield allows an Arduino board to drive the RGB LED Strip. Through control the 3 MOSFEET on the board,you can turn the RGB LED ON/OFF,and show colors differently.

You can also control the RGB LED Strip Driver Shield by the IR remote controller.

The RGB LED Strip Driver Shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.

Arduino uses digital PWM pins 9, 10, 11 to control the MOSFEET on the RGB LED Strip Driver Shield. and the digital pin 4 is used to receive the IR signal.These pins cannot be used for general i/o.

The shield have a fuseit can limit the current.

Specification

Supply voltage:<=12V

Compatible Uno, Mega, Romeo......

Compatible with 12V RGB LED Strip

Maximum power is 72W, 2A per way