Pololu A4990 Dual Motor Driver Shield for Arduino

This motor driver shield and its corresponding Arduino library make it easy to control a pair of bidirectional, brushed DC motors with an Arduino or Arduino clone. The board features Allegro_s A4990 dual H-bridge motor driver IC, which operates from 6 V to 32 V. It can deliver a continuous 0.65 A to each motor channel, and the current control feature of the A4990 limits the peak motor current to about 0.9 A per channel with the onboard sense resistors, making this shield well suited for low-current, high-voltage motors.

The shield ships fully populated with its SMD components, including the A4990 driver and a FET for reverse battery protection; header pins for interfacing with an Arduino and terminal blocks for connecting motors and power are included but are not soldered in (see the Assembly with included hardware section below).

The shield uses digital pins 6, 7, 8, 9, and 10 for its diagnostic and control lines. It should be compatible with any board that has a standard Arduino pin arrangement and the ability to generate PWM signals on pins 9 and 10, such as an Arduino Uno, Leonardo, Due, or Mega 2560.

This shield is intended to provide a low-cost, basic motor driver option for Arduinos, so it is much smaller than typical Arduino shields and does not include pass-through, stackable headers. For higher-power drivers with more configuration options, see our larger MC33926 and VNH5019 motor driver shields.

For a lower-voltage, higher-current alternative to this shield, please consider the DRV8835 dual motor driver shield. We also have a smaller A4990 carrier for those using something other than an Arduino or with tighter space constraints.

Features

• Dual-H-bridge motor driver: can drive two DC motors or one bipolar stepper motor
• Motor supply voltage: 6 V to 32 V
• Logic supply voltage 2.5 V to 5.5 V

Output current: 0.65 A continuous per motor

• Current control limits peak current to 0.9 A per motor
• Can work with ultrasonic (> 20 kHz) PWM frequencies, which allows for quieter motor operation
• Shield can optionally power the Arduino base directly when motor supply voltage is suitable

Arduino library makes it easy to get started using this board as a motor driver shield

Robust:

• Reverse-voltage protection on the motor power supply
• Can survive input voltages up to 40 V
• Under-voltage and over-voltage protection
• Over-temperature protection
• Short-to-supply, short-to-ground, and shorted-load protection on the motor outputs